2 Pack Inline Tail Light Power Harness Adaptors For Lighted Whips & Chase Lights

For 2015+ RZR, General 900/1000 XP 1000 Pro Turbo RS1

• Number in Pack: 2
• Socket Type: 4 Pin
• Type: Wiring Pigtail
• Wire Gauge: 18 AWG (1.0 mm)
• Wire Quantity: 3

Built right here in the USA using premium NAMZ 18 gauge wire and Delphi connectors; no cheap knockoffs with broken locking tabs.
If you're not sure about compatibility, check your tail light plug. If it matches this 4-pin connector, you're set to go!

• Simple installation:
  1. Install your whip or chase lights.
  2. Use the included solder/shrink connectors to attach your adapter.
     • Black for ground
     • Yellow for running lights / key-on power
     • Red for brake light activation
  3. Unplug your tail light connector.
  4. Plug the adapter harness into your tail light and OEM harness.

A note about high current accessories: If using high draw chase bars or rear lights, the OEM wiring and fuse box may not be capable of supplying the required current. If so, use the adapter to trigger a relay with direct attachment to the battery, bus bar, or distribution block. Contact us for details or custom wiring builds.